Absolute Measurement CLT Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Перетворювач Absolute Measurement CLT. Absolute Measurement CLT 9 сторінок.

Transducer Instruction Manual

Range:

Ultra

Type:

CLT

Revision:

V1.0

2.5

CLT-FLCM Installation

Four mounting holes should be drilled in the machine frame to accept the split flange. Loosen, but do not

remove the two clamping bolts for the split flange. Rotate the transducer in the split flange so that the

tension resultant force is in line with the "LOAD LINE" label as shown, then tighten the two clamping

bolts for the split flange. The cable connector should bisect the web wrap angle.

Secure the transducer firmly to the machine frame with four mounting bolts.

2.6

Mount the transducer and fix firmly to the machine frame with two fixing bolts. Loosen, but do not remove,

the four socket head screws retaining the lockplate on to the rear of the transducer. Rotate the transducer

body so that the tension resultant force is in line with the "LOAD LINE" label as shown, then tighten the

lockplate retaining screws.

2.7

Remove the four socket head retaining screws and the lockplate on the rear of the transducer. Insert the

transducer into the hole bored in the machine frame. Rotate the transducer in the machine frame so that

the tension resultant force is in line with the "LOAD LINE" label as shown, then secure the transducer

firmly in the machine frame using the lockplate. A spacer over the transducer body may be used if

required.

_____________________________________________________________________________________________________________________

Absolute Measurement Ltd. (T/A CMC Controls)

t: (0) 1732 763278

| e:

Unit 19

| Silver Birches Business Park | Aston Road | Bromsgrove | B60 3EU

| w: absolutemeasurement.co.uk