Anslut 411-119 Інструкція користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція користувача для Обігрівач Anslut 411-119. Anslut 411-119 9 сторінок. Convector heater
NOTE: The appliance may emit a slight smell or fumes the first time it is used, or if it has not been used
for some time. This is normal and soon stops.
Assembly
Before using the appliance, fit the feet (supplied unassembled in box). The feet must be fitted on the
underside of the appliance with the 4 self-tapping screws. Make sure they are correctly positioned at each
end.
Use
1.
Put the heater in a suitable place, with due consideration to the above safety instructions.
2.
Plug the power cord into a suitable mains outlet.
3.
Turn the thermostat knob to max.
4.
Switch on the appliance with the power switches on the side panel. The switches will light up when
the appliance is switched on. Switch on both switches for maximum heat.
5.
When the required room temperature has been reached, slowly turn the thermostat knob
anticlockwise until you hear a click and the switches go off. The appliance will then switch on and
off automatically to maintain a constant room temperature.
6.
When the thermostat knob is in the minimum mode (turned anticlockwise all the way) the appliance
is in frost mode. The thermostat keeps the temperature above 0°C in this mode, depending on the
size of the room.
•
Unplug the power cord and allow the appliance to cool before cleaning.
•
Clean the outside with a damp cloth and wipe dry with a dry cloth.
•
Do not use detergents or abrasive agents. Make sure that no water gets into the appliance.
•
Store in a dry and clean place, protected from dust.
ENGLISH
DESCRIPTION
OPERATION
MAINTENANCE
9
1.
Power level control
2.
Temperature control
3.
Recessed handle
4.
Air outlet
5.
Feet