ANSMANN 3400-0069 Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Освітлювальне обладнання ANSMANN 3400-0069. ANSMANN 3400-0069 2 сторінки. Light module

Друкувати сторінку

Assembly instructions for light module (PArt no. 3400-0069)

1. Parts required:

> Light Module (included)

> Dynamo Module (included)

> Two-wire light cables approx 50 cm (not included)

With the ANSMANN LM you can power a bike light directly from the Pedelec battery pack.

The bike light will use a negligible amount of power from the battery pack

Should the bike light's battery run down; the light will still work with power generated from the Bicycle Dynamo (StVZO Licensed).

2. Assembly instructions:

1 Open the controller box and remove the controller. Connect the LM reverse-polarity protection 2-pin cable plug (red and white) to the

free slot on the controller (red-black).

2 Remove the cable of the front and rear lights from the dynamo

3 Connect the cable of the DM to the dynamo. (Black: positive connection, Black/White: earth connection)

4 Connect the cable to the rear light with the DM slot (Black: positive connection, Black/White: earth connection)

5 Use the two-wire cable to connect the DM and the LM.

6 Connect the Front light cable with the LM (Black: positive, Black/White: earth connection).

7 Put the LM back into the controller box with the cable. Secure the DM to the frame with cable ties.

AnsmAnn Ag . Industriestraße 10 . 97959 Assamstadt

Tel.: +49 (0) 6294 4204 0 . Fax: +49 (0) 6294 4204 4400 . [email protected] . www.ansmann.de