3NOD AUDIO&VIDEO SPF4008P Інструкція з експлуатації Посібник з експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Цифрова фоторамка 3NOD AUDIO&VIDEO SPF4008P. 3NOD AUDIO&VIDEO SPF4008P 14 сторінок. With speaker stand
Друкувати сторінкуPC Sync Display Function
We have a PC sync display software in the driver disc of this set. File name: EZ display.
You can install the software to your computer as the way you install any software. After installation, the
computer may remind you to restart the computer, do as the instruction. Then connect the DPF set and your
computer by USB cable, run the software, below soft- ware surface will show on you computer.
Click DISPLAY DEVICE, the display on your computer will also show on the screen of DPF set. Using this
function, two people can watch photos or movies on your computer and DPF set together. But no sound
come out from the DPF set. Select the selections under Mirror Display and Exten-
sion Display to adjust the display of the DPF screen. Select STORAGE DEVICE, computer screen will disap-
pear from the DPF screen, the DPF set will restore to a removable device for you to transfer files.
Trouble shooting
In case you meet some problems when you use this set, please read below informations before you call for technical
assistance or return the set.
Symptom
Remedy
1. Please only use the attached AC adaptor. 2. Please check if the AC
adaptor firmly plugged into the power outlet. Make sure your out let has power.
3. Please remember to press the power button on the speaker to turn on the set.
No power.
4. One of the safety mechanisms may be operating. In this event, unplug the
set from power outlet and plug it again.
1. Verify that there are correct files in the internal storage or you have
inserted a memory card or other component device into the proper slot.
The
set
Only JPEG/BMP/JPEG Progressive/ EXIF/MP3/WMA/AAC/WAV/M-Jpeg/
doesn't work.
Mpeg4/H.264(D1) files can be played.
2. Enter to Source menu to select source.
1. The distance is too long or the angle exceeds 30 degrees.
The remote
2. The battery of the remote control is no power.
control does
3. The remote sensor is perturbed by another luminous source
not work.
Your set dies or
This may be caused by an electrostatic environment. Please disconnect the set
goes back to its
from the power and reconnect it.
welcome screen.
I t
c a n ' t
b e
1. Please turn on the set when connect it to PC. 2. Please reconnect the set
detected when
and your PC. 3. Please try to plug the
connect the set
USB port of your PC.
to PC.
big plug of the USB cable to another
9