28 GORILLA 28-0010038 Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Регулятор температури 28 GORILLA 28-0010038. 28 GORILLA 28-0010038 4 сторінки. Ae wireless temperature sensor
Друкувати сторінкуCharging
***It is recommended to fully charge the device before first time use.***
***If the WTS is not positioned correctly within the charging station, it will not charge.***
In order to charge the WTS units, the User must:
1. Plug the AC wall adapter into a powered wall socket.
2. Connect the USB cable into the AC wall adapter (USB-A) and into the wireless charging station.
a. The User should see the wireless charging station's indicator led illuminate within 10
seconds of power on.
3. Place the WTS units in their proper orientation on the wireless charging station.
WTS Placement
After the wireless charging station is powered on. The user may place the Wireless Temperature
Sensors WTS in any order onto the wireless charging station. The WTS and wireless charging station are
keyed in order to indicate the proper placement of the WTS within the wireless charging station. The WTS
should be placed correctly within the slots with the notched grove on the bottom and closest to the outside
edge of the wireless charging station. Allow the WTS to lie flat within the slots of the wireless charging
station. If the WTS is not flat when placed onto the wireless charging station the user must remove the
WTS and replace the WTS within the wireless charging station correctly in order for the WTS to charge. If
a WTS is not positioned correctly within the wireless charging station it will not charge.
Charging Notes
First time charge may take up to 24 hours. It is recommended to fully charge the WTS before first
time use by leaving the WTS within the charger for 24 hours. User is able to read the battery state of
charge and charge status through the mobile application.
After first charge, normal charge times may range between 10 to 12 hours when the WTS begins
charge with a partially drained internal battery.
It is recommended to allow the device to fully charge before use. However, the device may be used
without reaching the fully charged state. The User in this case may see degraded performance in the WTS
operational time in normal operational mode.
Once charge is completed the user must leave the WTS units in a powered wireless charging
station until needed for use. As the removal from the wireless charging station will trigger the WTS to exit
the charge mode and enter normal operation which will discharge the battery.