AirTime ATX6 Посібник з встановлення та експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з встановлення та експлуатації для Трансивер AirTime ATX6. AirTime ATX6 16 сторінок. Wireless wall clock transceiver
Друкувати сторінкуATX6 Installation and User Guide
4. Attach the UHF Antenna to the ATX6's BNC Connector
and place it on top of the ATX6 or on a shelf within 12
feet.
If an external amplifier is used, attach the amplifiers
cable to the "RF IN" BNC connecter and to the BNC
connector on the ATX6. Connect the antenna to the
"ANT" BNC connector and place the antenna in the
desired location.
IMPORTANT: Refer to function 19 of the setup on page
12, this function must be enabled when using an
amplifier.
For best performance, mount the antenna in a vertical
position not horizontal
5. If synchronizing the ATX6 to an ATX-GPS, attach the
cable to the RJ-45 Modular Jack, and mount the ATX-GPS
according to the instructions included in its package.
6. If synchronizing the ATX6 to a Lathem Master Clock or
LTR-GPS, or if synchronizing a Lathem Master Clock or
DWA-S to the ATX6 via RS-485, install a Cat-3 or Cat-5
(UTP) Cable between the Terminal Block connections on
the ATX6 and the connections on the other unit, taking
note of signal polarity: plus to plus / minus to minus.
7. If synchronizing the ATX6 to Lathem's AirTime TimeSync
Software using an Ethernet to RS232 Adapter (Lathem
part # TXTOSER) and cable, install the Ethernet to RS232
Adapter according to the instructions included with its
package.
Install and execute the AirTime TimeSync Software
according to the instructions included with its package.
8. If synchronizing another system to the ATX6, or if
synchronizing the ATX6 to another system via "Dry
Contact" (Relay) Closure, install a Cat-3 or Cat-5 (UTP)
Cable between the Terminal Block connections on the
ATX6 and the connections on the other unit.
9. If synchronizing another system to the ATX6 using the
Remote Wireless Relay Option, install the Wireless Relay
at the remote location, according to the instructions in
its package.
Page 5
Synchronizing a LTR0 or DWA-S to an ATX6
Synchronizing a DDC2/4-RS to an ATX6
ATX6 Installation and User Guide
Page 22