ATT Holding Kade KZ-700-U/H Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з монтажу для IP-контролери доступу ATT Holding Kade KZ-700-U/H. ATT Holding Kade KZ-700-U/H 12 сторінок. Integrated access controller
Друкувати сторінкуIntegrated Access Controller – Installation manual
To add card user (Method 3)
Add a series cards users – Block Enrollment
The card number must be consecutive.
(This operation is only for Zone 1)
To delete a card user by card
Note: Users can be deleted continuously without
exiting from programming mode
To delete a card user by user ID
This option can be used when a user has lost
their card
To delete a card user by Card number
Card and PIN mode (3 1 1 # for Zone 1 or 3 2 1 # for Zone 2)
To Add a card and PIN user
(The PIN is any 4~8 digits between 0000 &
99999999 with the exception of 1234 which is
reserved.)
To change a PIN in card and PIN mode (Method
1) Note that this is done outside programming
mode so the user can undertake this themselves
To change a PIN in card and PIN mode (Method
2)
Note that this is done outside programming
mode so the user can undertake this themselves
To delete a Card and PIN user just delete the
card
Card ONLY mode (3 1 0 # for Zone 1 or 3 2 0 # for Zone 2)
To Add and Delete a card user
To delete All users
To delete All users
Note that this is a dangerous option so use with
care
To set card users by Manager card (This operation is only for Zone 1)
To add Card User by Manager Add Card
To delete Card User by Manager Delete Card
To unlock the door
For a PIN user
For a card User
For a card and PIN user
All rights reserved. © AAT HOLDING S.A.
1 0 User ID number # Card number #
Card quantity #
Card quantity is between 1-2000.
(EM Card, the first 10 digits card number or last 8 digits
card number on the card)
2 0 Read Card
#
The devices can automatically identify the card of Zone
1 or Zone 2
2 0 User ID number #
2 0 Card number #
Users can be deleted continuously without exiting from
programming mode
Add the card as for a card user
Press * to exit from the programming mode
Then allocate the card a PIN as follows:
* Read card 1234 # PIN # PIN #
* Read Card Old PIN # New PIN #
New PIN #
* User ID number # Old PIN # New PIN #
New PIN #
2 0 Read Card
# or
2 0 User ID number #
The operating is the same as adding and deleting a
card user in Card or PIN Mode
2 0 0000 #
2 1 0000 # Delete ALL users of Zone 1
2 2 0000 # Delete ALL users of Zone 2
Manager add card Read user card Manager add card
Cards can be added continuously.
Manager delete card Read user card Manager delete
card
Cards can be deleted continuously.
Enter the PIN then press #
Read card
Read card then enter PIN #
9