AirTime Hoops 660 Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Ігрові набори та обладнання для дитячих майданчиків AirTime Hoops 660. AirTime Hoops 660 11 сторінок.

Друкувати сторінку

A. Slide the Actuator(B) to the last set of welded tubes

on the Main Extension Arm (F), Using a Hex bolt

M16X295MM (#5), two M16 Flat Washers((#12), and

a Hex Nut M16(#18) at the top. And using a Hex Bolt

M16x135mm (#9), two Washers for M16 Bolt (#12), two

Nylon washers (#2), and one Hex nut for M16 bolt (#18)

on bottom to tighten the Actuator.

Note: Make sure the Nylon Washers go between

Actuator and Mounting Bracket .

A. Slide Steel Sleeve (J) thru the tube welded at the top end of

Spring- Assist Cartridge (C) Slide the Plastic rim Height Indicator

(K) over Steel sleeve, leave it beside the Spring-Assist Cartridge

(C). Place the top of Spring-Assist between Main extension (F),

align the Steel Sleeve (J) with the second set of welded tubes on

the Main Extension Arm (F), Slide one Washer M16 (#12) over one

Hex Bolt M16x295mm (#7), and slide this Bolt all the way thru Main

Extension Arm (F), one Nylon washer M16 (#2), and the other side

of Main Extension Arm (F). Secure it with one Flat Washer M16

(#12) and One Hex nut M16 (#18).

Do not over tighten this bolt because this is the pivot point. Make

sure the Plastic rim Height Indicator (K) hangs freely along side of

Spring-Assist Cartridge.

Note: Nylon washer locates between Steel sleeves (J) and Main

Extension\Arm (F).

B. Attach the bottom of Spring-assist Cartridge (C) to the Main pole

Bracket by using a Hex Bolt M16x120mm (#8), two Flat Washers

M16 (#12), two Nylon Washers M16 (#2) and a Hex Nut M16 (#18).

Note: Nylon washer goes between Bracket and Cartridge (C).

C. Remove and discard the spreader from the top of the Spring-Assist

Cartridge (C).

A. Attach the 2 Upper Extension Arms (G) to Main Post (A) with a

Hex Bolt M16x245mm (#6), two Flat Washers M16 (#12), two

Nylon Washers (#2) and one Hex Nut M16 (#18).

Do not tighten at this time.

Airtime Model 660