Attache PID-100 Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Сканер Attache PID-100. Attache PID-100 7 сторінок. For notebook computers

DECLARATION OF CONFORMITY

We Antec Incorporated, 47900 Fremont Blvd, Fremont, CA 94538 USA,

Telephone: 510-770-1200, declare under our sole responsibility that the produc

complies with part 15 of the FCC Rules. Operation is subject tothe following two

conditions:

(1) This device may not cause harmful interference and (2) this device must accept

any interference that may cause undesired operation.

Note: This equipment has been tested and found tocomply with the limits for

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and

can radiate radio frequency enegry and, if not installed and used in accordance

with the instruction, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or tele-

vision reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

Reorient the receiving antenna.

Increase the separation between the equipment and receiver.

Move scanner away from the receiver.

Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

PID - 100

Attaché User's Manual

Trademarks

IBM, PC and VGA are registered trademarks of International Business

Machines Corporation.

MMX is a registered trademark of Intel Corporation.

MS-DOS, Windows, Windows 95, Windows 98, Windows NT and

Microsoft are registered trademarks of Microsoft Corporation.

All other trademarks are the properties of their respective owners.

Contents

- Installation and Calibration

- Pre-defined Setting

- Custom Setting

- Information Window