DSPPA MP 2000 Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Підсилювач DSPPA MP 2000. DSPPA MP 2000 11 сторінок. P.a.series public address amplifiers
Також для DSPPA MP 2000: Посібник користувача (4 сторінок)

Друкувати сторінку

OPERATING PRECAUTIONS

Make sure the AC mains voltage is correct and is the same as that printed on the rear of the amplifier.

Damage caused by connecting the amplifier to improper AC voltage is not covered by the three-year US

warranty.

Make sure the power switch is off before making any input or output connections. It is always a good

idea to have the gain controls turned down during power-up to prevent speaker damage if there is a high

signal level at the inputs.

If the PROT Led goes on steadily while power has been turned on and signal has been fed, there must a

trouble of output shorted. Please turn it off and correct the trouble then turn it on again.

CONNECTING INPUTS

Input connections are made via either the 3-pin XLR-type

connectors (Figure1/2 ) or 6.35mm sockets on the rear side of the

amplifier.

CONNECTING OUTPUTS

Output terminals are on the rear panel. Load can be

connected using banana plugs or spade lugs. A black binding post

is considered "COM", while the three red binding posts are

considered "hot".

Usually make use of "fixed voltage" (70V or 100V) output,

while the each loudspeaker should use a separate transformer and

the total power of connecting loudspeakers should be less than rated power of amplifier.

Loudspeaker which close to the amplifier also make use of P1 output, while the total resistance of connecting

loudspeakers should accord with 4Ω.

Note:

When connecting loudspeakers, it is better to use one pair of output terminals only.

Never connect the "hot" terminals together.

ground

Figure 1 3-pin XLR-male connectors

signal

Figure2 3-pin XLR-female connectors

signal

ground