DSPPA MX1000II Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач DSPPA MX1000II. DSPPA MX1000II 9 сторінок. Professional two-channel stereo amplifier

Друкувати сторінку

3. Connection Instructions

3.1 Input interface description

The two channels of the machine signal on the rear panel of the XLR interface and 6.35mm interface input,

are non-balanced input mode. Two interfaces for the parallel connection, the connection can only use one of the

interface connection.

XLR interface wiring shown below：

3.2 Output connection instructions

The speakers can be connected with banana or shovel. When the stereo is running, the red terminal is "hot

port" and the black terminal is the signal ground. When the bridge is running, the speakers are bridged between

two red bars (between two "hot ports"), and the ground is useless.

If the machine is alarmed after the power is applied and the machine alarm is activated (the protection

indicator is on), it means that the output circuit may be short-circuited. The power supply should be cut off

immediately, and the power supply should be re-energized after troubleshooting.

3.3 Power input description

The MX Series Stereo Amplifier uses the following power supplies

(110V AC / 220V AC) :

110V AC

220V AC

Marked on the rear panel of the machine

MX1000II

MX1500II

14A

17A

6.5A

MX2000II

MX2500II

20A

24A

10A

12A

Conference Amplifier