DSPPA MAG6701 Інструкція - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція для Сенсорні термінали DSPPA MAG6701. DSPPA MAG6701 4 сторінки. 100v network terminal
Також для DSPPA MAG6701: Посібник користувача (20 сторінок)

Друкувати сторінку

Front / Rear Panel

VOL+

Net Service

Timing

Signal

USB

Set

VOL-

1 2 3

4 5 6

button

USB disk playing mode: to play previous song.

setting mode: move left/move right to view/set parameters.

2 Play/Pause button

To control play/pause of local MP3 program playback.

When setting address, this button is used to save the

settings.

Network indicator (Net Service)

When this device is successfully connected to host through

Network, this indicator will be turned on.

4 Timing indicator (Timing)

This device could execute timing function without host

control. When executing, indicator will be turned on.

5 Amplifier output level indicator (Signal)

This indicator will be turned on when there is signal output

from this terminal. This indicator will be brighter when

increasing volume and it will be darker when turn down

volume.

6 USB button

U disk play/pause button. When setting IP, this button could

be used to exit setting status.

7 F1 button

Use when adjust volume. This button could be used to

switch among AUX IN, MIC IN/MIC 2, and MP3.

[email protected]

100V Network Terminal MAG6701

STBY

100V Backup

Protect

10 11 12 13 14 15 16

www.dsppatech.com

8 Local setup button (Set)

Long press this button to enter IP address view status. Press

again to enter IP setup/modify status.

9 VOL- button

Play mode: to turn down volume.

View IP: to select parameter to be viewed.

Set up IP: to increase or decrease parameters.

10 Amplifier protection indicator

This indicator will be turned on when there is short circuit.

11 100V input

When there is 100V input, this indicator will be turned on.

12 Standby indicator (STBY)

Standby function indicator which is also a mute function

indicator. When there is a Network alarm and emergency, it

will be turned on. Alarm and emergency signal could

suppress mute function.

13 VOL+ button

Playing mode: volume up.

IP viewing mode: to switch among parameters.

IP setting mode: to increase or decrease parameters.

button

U disk playing mode: to play next song.

IP setting mode: move right to view/set parameters.

Digital display screen and receiving window of

infrared remote

Digital display screen will display working status and

Network information. There is a built-in receiving window

of infrared remote to receive remote control.

16 Screw fixing hole

This terminal could be installed on the wall. There are

four screw fixing holes which are used to fix the device on

the wall.

The specifications will be subject to change without prior notice.