Atten ST 80 Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Паяльний пістолет Atten ST 80. Atten ST 80 16 сторінок.

Друкувати сторінку
stand by �me se�ng mode and display panel will show current stand by �me. Press
stand by �me and press #1 to save it.
Note: Stand by time can be set between 1 minute and 120 minutes and stand by function will be
disabled as setting content is "OFF"(Figure 15).After enabling stand by function, soldering station
will enter stand by state if no soldering work or any other control panel operations taken throughout
during stand by time, and the temperature will decline to 150
stand by state, picking solder iron handle or any operation on control panel can wake up soldering
station and soldering station will continue to work in preset temperature value.
11. Se�ng automa�c shutdown �me
a) In system se�ng mode, press
shutdown �me se�ng mode and display panel will show current shutdown �me set value.
Press
or
to set shutdown �me as 1 minute ~ 120 minutes or OFF and press #2 to save it. It
will disable automa�c shutdown func�on as se�ng content is "OFF".
Note: Automatic shutdown function only can be enabled as automatic stand by function set on.
Soldering station will enter shutdown state, stop heating and don't turn off display panel until
temperature has declined to 100
After entering shutdown mode, any operation on control panel will make no sense after
entering shutdown mode. The soldering station only can exit this mode after user switch power
off and restart it.
b) In shutdown mode, soldering sta�on is not in real power off state which s�ll consumes li�le
energy as soldering sta�on is well connected with power supply. To ensure safety, please turn
off power switch or pull power plug out.
12. Touchtone func�on
12.1 In system se�ng mode, press
Figure 15
to go to second se�ng page(Figure 8). Then press #2 to enter
as the time in stand by state exceeds preset shutdown time.
Figure 18
to go to second se�ng page (Figure 8). Then press #3 to enter
8
and be stabilized around 150 .In
Figure 17
Figure 20
or
to set
Figure 16
Figure 19