Attero Tech unD6IO Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Attero Tech unD6IO. Attero Tech unD6IO 18 сторінок. 4x2 multi-io dante wall plate interface
Друкувати сторінкуConnection to the Dante network is provided by a single Ethernet RJ45 connector on the back of the unit. The unD6IO is
PoE-enabled which allows the unD6IO to be powered over its network cable from a suitable PoE source (IEEE 802.3af)
eliminating the need for a local power supply. This is particularly useful as the unD6IO can then be mounted in remote
location where access to a mains outlet would be limited or indeed, non-existent.
Audinate's Dante Controller or other 3rd party manufacturer's Dante routing software can be used to control the audio
routing configuration of the device while the Attero Tech unIFY Control Panel application (V2.0 or later) or supporting
DSP partner software can be used to configure the device-specific features.
The unD6IO also supports third party control systems allowing external configuration of its settings such as phantom
power and input gain in real time. Further information on 3
section 2.3 – 3
Party Control.
rd
1.1 – What's in the Box
The device comes supplied with the following:
(1) unD6IO
o
(1) 2-gang Decora cover plate cover w/mounting screws
o
(1) 6-position Phoenix plug connector
o
1.2 – Optional Extras
The following are available as options for the unD6IO and that may be ordered separately:
unAX2O - Passive Dual XLR Male single gang Decora wall plate - P/N: 900-00187-01
o
(Comes with 3-gang Decora cover plate).
Attero Tech LLC 2017
party control can be found later in this document in
rd
Page 6
unD6IO
User Manual
614-00029 Rev 02_b