3onedata ES209G-1GF Посібник з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з монтажу для Перемикач 3onedata ES209G-1GF. 3onedata ES209G-1GF 2 сторінки. Unmanaged ethernet switch
Також для 3onedata ES209G-1GF: Посібник з монтажу (2 сторінок)
Друкувати сторінку
Tips:
Insert a little to the bottom, lift upward and then insert
to the top.
Step 3
Check and confirm the product is firmly installed on
DIN-Rail, then mounting ends.
【Disassembling DIN-Rail】
Step 1
Device power off.
Step 2
After lift the device upward slightly, first shift out the
top of DIN-Rail mounting kit, then shift out the
bottom of DIN-Rail, disassembling ends.
Attention before power on:
Power ON operation: first connect power line to the
connection terminal of device power supply, then power
on.
Power OFF operation: first unpin the power plug, then
remove the power line, please note the operation order
above.
【Power Supply Connection】
DC power supply
The device provides 4 pins 7.62mm pitch
power supply input terminal blocks and
two
independent
systems for PWR1 and PWR2. The power
supply supports anti-reverse connection.
Power supply range: 12～48VDC
【DIP Switch Settings】
The device provides 4 pins DIP switches for
function settings, where "ON" is enable valid
terminal. Please power off and power on after
changing the status of DIP switches. DIP
switches definition as follows:
DIP
Definition
Operation
1
Flow control
Set the DIP switch to ON
-
2
Reserved
3
Set the DIP switch to ON, fiber
Port isolation
DIP
Definition
4
Reserved
【Checking LED Indicator】
The function of each LED is described in the table as below:
LED
P1/P2
Link/Act
(G1-G9)
【Specification】
Panel
Gigabit copper port
Gigabit fiber port
DC
power
supply
Indicator
Exchange attributes
Backplane bandwidth
Packet buffer size
MAC table size
Power supply
Input power supply
Access terminal
Consumption
Operation
port can communicate with
copper port. Copper ports can't
communicate with each other.
-
Status
Description
ON
P1/P2 is running normally
P1/P2 is disconnected and running
OFF
abnormally.
ON
Ethernet port connection is active.
Blinking
Data transmitted
OFF
Ethernet port connection is inactive.
10/100/1000Base-T(X), RJ45,
automatic flow control, full/half
duplex mode, MDI/MDI-X
autotunning
1000Base-FX, optional
SC/ST/FC
Power indicator, interface
indicator
20G
1Mbit
8K
24VDC (12~48VDC)
Support dual power supplies
redundancy,
reverse-connection protection
4 pins 7.62mm pitch terminal
blocks
No-load
3.9W@24VDC
Full-load
8.1W@24VDC
Working environment
Working temperature
0~55℃
Storage temperature
-10~65℃
Working humidity
5%~95% (no condensation)
Protection grade
IP30 (metal shell)