ATTO Technology ExpressSAS H608 Посібник з усунення несправностей - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з усунення несправностей для Хост-адаптер ATTO Technology ExpressSAS H608. ATTO Technology ExpressSAS H608 9 сторінок. 6-gb host adapters
Також для ATTO Technology ExpressSAS H608: Технічна специфікація (2 сторінок), Посібник з вибору (1 сторінок)

ATTO Technology ExpressSAS H608 Посібник з усунення несправностей
The computer's BIOS scan recognizes the ExpressSAS RAID controller, but only
detects connected SAS/SATA devices on one of the connectors. The other bus
reports no devices.
Note: I you are using a R348 SAS Controller be sure the controller is configured to
use the appropriate ports you need. This card can be configured to use all internal
connectors or one internal and one external.
Swap the devices
working with the one having issues. If the issue follows the bus and there is an
expander in the Array, move on to next step. If there is no expander, replace the
card.
If there is an Expander in the Array verify the following:
Zoning: Verify the Expander(s) are zoned properly so that the
ExpressSAS Raid card and the SAS/SATA drives have access to one
another. If there are pre-existing zones setup, be sure to add the
ExpressSAS Raid to the zone.
If the issue follows the attached SAS/SATA devices, troubleshoot the attached
devices:
Verify the SAS/SATA devices are powered on.
Verify the drives are mapped to the controller correctly. You may need to
execute the 'automap' command to remap the drives. This can be done in the
ATTO Configuration Tool or the controller utilities (CTRL-Z).
Check cable integrity. Check the cables for solid connections. Make sure they
are snapped in. Inspect cable ends for bent pins.
Try attaching SAS/SATA devices one at a time with different cables, adding
drives and cables until the problem occurs. This will help pinpoint the device or
cable causing the problem.
Watch the LED indicators on the SAS/SATA devices before, during, and after
startup. Drive lights should also flash at startup as the SAS/SATA bus is
scanned. This may give a clue as to the root cause of the issue.
The ExpressSAS RAID controller is detected during the system's BIOS scan but
it is not detected by the operating system.
Note: When working properly, the ExpressSAS RAID controller will show up in
the device manager.
Page 4 of 9
and cables
from the SAS/SATA bus that appears to be
Atto Technology, Inc.
June 6, 2007