DT Research DT381RP Основний посібник з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Основний посібник з експлуатації для Планшет DT Research DT381RP. DT Research DT381RP 5 сторінок. Rugged tablet

Друкувати сторінку
The DT381RP
D
4
C
A
B

Input/Output Ports

USB Type-C Port
A
Audio Jack
B
USB Port
C
Ethernet Port
D
Data Capture Modules
E
Micro SD Card Slot
Front/Back Cameras
F
2
F
2
3
1
F
E

Button Functions

BUTTON
ACTION
Power Button
1
Windows Key Button
2
3
Programmable Buttons
Brightness Control Buttons
4
PRECAUTIONS
•
Always exercise care when operating and handling the DT381RP.
•
Do NOT apply excessive pressure to the display screen.
•
We recommend using the Digital Pen (optional) to keep the screen clean.
•
Avoid prolonged exposure of the display panel to any strong heat source.
Wherever possible, the DT381RP should face away from direct light to reduce
glare.
•
If the AC-DC power adapter is used to recharge or power the tablet, do NOT
use any AC-DC adapter other than the one provided or acquired from the
manufacturer or its partners.
•
In the unlikely event that smoke, abnormal noise, or strange odor is present,
immediately power off the DT381RP and disconnect all power sources. Report
the problem to your device provider immediately.
•
Never attempt to disassemble the DT381RP, as this will void the warranty.
NOTE:
To obtain protection consistent with any IP rating for the device, the I/O (audio,
power, USB, card reader, etc.) port doors must be closed. If the IP protection is
compromised by mishandling or misuse, such as by leaving port doors open or
improperly closed, any resulting product damage will not be covered under any
DT Research warranty.
BASIC FEATURES
The DT381RP rugged tablet integrates a bright display, USB ports, and embedded
networking elements such as wireless LAN or optional 4G.
A DT381RP typically integrates an 802.11ac wireless LAN (WLAN) adapter that may
connect to other wireless devices or access points. If your DT381RP does not come
with such a network adapter, please consult your device provider to establish the
desired network connectivity.
OPERATION
Powering ON and OFF
To activate DT381RP, push and quickly release the Power Button. The display will come
on in a few seconds. To put the DT381RP in standby mode, push and quickly release
the Power Button. To turn the DT381RP off for extended storage, power off safely using
any software function that "shuts down computer" provided in the software operating
system.
NOTE:
The battery packs shipped with your tablet may be low in power - please use
the AC-DC adapter with the DT381RP when setting up for the first time to fully
charge the battery pack.
NOTE:
To conserve power, push and quick release the Power Button to make the tablet
in standby mode while not in use. Pushing briefly on the same butt on will wake
up the system.
3