Airtopia Control4 Інструкція з монтажу та використання - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з монтажу та використання для Регулятор температури Airtopia Control4. Airtopia Control4 8 сторінок.

Друкувати сторінку

5. Highlight the 'Airtopia Climate Control' driver on the left hand side of the System Design page.

6. Select 'True' in the dropdown box for the 'Show Driver Config' property.

7. Set up the IP Address for the unit. The port should be left as default unless the manufacturer changes the port

number in future.

8. Due to limitations in Control4 no additional controls can be added to Control4's user interfaces apart from Mode

and Fan Speed. As such properties have been given to provide a means to always set up the defaults for when

you turn on the system for the following.

Note: If the Default is set to 'do not send' then it will not send a command for that particular function.

9. If you wish to utilise the Contact Closure in the device then please specify how you want to use it here.

If you want to use it to tell the driver that the HVAC unit has been turned on or off manually (eg the

user uses the original IR remote to turn off the HVAC unit) then use HVAC on off status.

b. If you want to connect it upto another device to use in general Control4 programming then set it to

Other and bind a sensor based device to the Airtopia driver connections under the Connections tab in

Composer.

Note: As the Airtopia device requires polling for feedback contact closure status will take upto 10 seconds to

feed back into Control4. Please do not use this for time critical applications.

Page | 6