Bounce LED SIGNATURE Series Посібник із швидкого старту - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Освітлювальне обладнання Bounce LED SIGNATURE Series. Bounce LED SIGNATURE Series 5 сторінок. Blaster
Друкувати сторінкуInstallation Guide
WARNING Please read these instructions completely and carefully.
Risk of electrical shock. Disconnect power before servicing or installing product
1
Ensure the inside of your channel letter or sign box is clean and
free of debris. For best illumination
is white (matte finish preferred).
3
Note that LEDs are only cuttable every 3x modules. This is
indicated by a printed red marking on the wire.
Cut only where marked
5
Drill a suitably sized hole out the back of the sign for connection
to DC power supply.
SALES & SUPPORT
02 9517 3222 |
PH
E
www.bounceled.com.au
ensure the inside of the box
2
Using supplied LED layout, remove tape from module and press in
place. For best illumination, install modules two-thirds of the way
towards the back of the box for single sided signs and centralised
for double-sided signs
4
Secure LEDs by gluing modules in place.
6
Connect modules from the sign to power supply, making sure to
not exceed 15 modules per series. Exceeding 15 modules per
series will lead to voltage drop and uneven illumination.