Attonic AD-FG50 Посібник з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Вимірювальні прилади Attonic AD-FG50. Attonic AD-FG50 20 сторінок. Digital force gauge

7.Function settings and descriptions
To set each function, long press the "FUN" switch until you hear a beep.
"FUN" will be displayed at the top of the screen when the gauge becomes the function setting mode.
If "FUN" is not displayed, long press the "FUN" switch again until you hear a beep.
* Please note that it is set longer so that the measurement mode will not be switched due to a malfunction during
measurement.
To complete the setting, long press the "FUN" switch again until you hear a beep.
The screen will look as follows.
* The set data will not be saved.
Select "OK" if you want to save the data, or "CANCEL" if you don't, and press the "POW" switch.
* "DATA SAVE?" screen appears when you long press the "FUN" switch anywhere in the settings.
Select "OK" or "CANCEL" and press "POW" switch. The setting is complete When measurement screen appears.
7-1.Set measurement mode (Initial
・You can switch the measurement mode.
Switch between TRACK mode and PEAK mode by pressing the "DAT" switch.
The one with a black background is the one selected.
* Short press the "FUN" switch to confirm the setting. Next is the setting for changing measuring unit.
7-2.Change measuring unit (Initial Unit: N or kN)
・You can change the measurement unit.
 Switchable 3 units: N(kN), kgf(gf), lbf
* The unit symbol changes depending on the model.
* Short press the "FUN" switch to confirm the setting. Next is the setting for comparator HI.
The display changes every time
the "DAT" switch is pressed.
Setting:
TRACK)
TRACK: The torque value applied to the detector is displayed as it is.
It is used to view measurements that change constantly.
"DAT" Switch
PEAK: Hold and display the maximum absolute value during
measurement. Hold a torque value from 0.2% or more of the
maximum measured value of each model.
"DAT" Switch
PP: The screen will be displayed in two sections.
Centering on zero, the upper section is the + peak holding and the
lower section is the - peak holding. Both hold a torque value from
0.2% or more of the maximum measured value of each model.
"DAT" Switch
"POW" Switch
* The set data will be saved.
"POW" Switch
"POW" Switch