Auber WSD-1203CPH Посібник з експлуатації та інструкція - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з експлуатації та інструкція для Регулятор температури Auber WSD-1203CPH. Auber WSD-1203CPH 12 сторінок. Programmable pid temperature controller with dual probe

Друкувати сторінку

half of the lowest shelf that is close to the heater. Users should avoid placing the sensor

too close to the heater because it does not represent the temperature of the rest area.

When the shelves are filled, temperature variation might depend on how the foods were

placed. The bottom shelf can become hotter if more food is placed in it to block the hot

air from going up.

e) Operating the controller when ambient temperature is below 32 °F (0 °C). The

controller reading is only accurate for temperature ≥ 32 °F (0 °C). In addition, if the

ambient temperature is below 14 °F (-10 °C), the controller will not function because it

can't read the temperature correctly. In that case, users can warm the sensor by holding

it with their hands. Once the sensor is above 14 °F (-10 °C), it will turn on the heater.

Once the inside of the smoker is heated to above 32 °F, the controller will run by itself.

7. Program the smoker generator on step.

The smoker generator is controlled by the parameters R1 and R2. These two parameters

determine which steps to turn on the smoker generator. The smoker generator will stay

on only for the step it is programmed. It will turns off when program goes to the next step.

e.g. When R1=2, and R2=4, the smoker generator will be on during step 2 and 4. R1=0

or R2=0 means that R1 or R2 will not do anything to the smoker. The smoker will not be

turned on if both R1 and R2 are set to 0. R1 and R2 can be accessed through code 166

menu. For details, please read section 7 of the main manual.

8. Program the alarms.

The alarm setting can be accessed by code 188.

Table 2 shows the list of the parameters, their range and initial factory set value

able 2. List of control parameters and its initial settings under code 188

Symbol

AH1

AL1

AH2

AST

Detail of each parameter.

a) AH1 is the high limit alarm for probe 1. Users can set the temperature so that if the

system is out of control, the buzzer will be turned on. e.g. If AH1 is set to 290, the buzzer

will be on at 291 and off at 290. When the buzzer is on, the left window will flash between

AH1 and the current temperature.

b) AL1 is the low limit alarm for probe 1. e.g. If AL1 is set to 100. The buzzer will be on

when temperature drops to 100. It will be turned off when temperature rises to 101. This

Description

Probe 1 high limit alarm

Probe 1 low limit alarm

Probe 2 high limit alarm

Step finish alarm

Range

0-200 °C, 0-392 °F

On, OFF

Initial

290

200