AIRTRONICS RD6000 SPORT Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Іграшка AIRTRONICS RD6000 SPORT. AIRTRONICS RD6000 SPORT 7 сторінок.

Gain Values

Regardless of your gyro type, you must set an appropriate gain value. The gain value

tells the gyro how much it needs to amplify the compensation commands. Too low of

a gain value will let the tail drift easily, and too high of a gain valve will make the

gyro overcompensate which results in a tail that "wags." A good starting point is

50%, then adjust it as necessary after your test flights.

Any change that effects the speed or efficiency of the main or tail rotors can result in

a need to change the gain value. Some of the factors include:

Changes to your throttle or pitch curves

●

Changing the length or type of main or tail rotor blades

●

Forward flight, backward flight, or flight in a steady breeze (increases

●

efficiency because it brings lessturbulent air to the rotors.)

Pinion gear, main gear and motor

●

Tail drive gears / pulleys

●

Compensation Mixers, and Channels 7 / 8

Your remote control helicopter's setup is now complete. This section covers optional use of the two

available compensation mixers. A CMix will mix one channel with another, allowing you to link them.

Some of the reasons for the using the CMix include:

Reduce CCPM Interactions

CCPM interactions occur when an unintended swash plate movement results from a control

input. For example, when applying a full collectivepitch command, your swash plate may also

tilt forward slightly which would add an unintended forward cyclic effect. This is the result of

imperfect linkage geometry, and the fact that no two servos are completely alike.

You can mix Pitch to Aileron and/or Pitch to Elevator to counteract this effect.

Help Maintain a Constant HeadSpeed Without Using a Governor

Any cyclic control input will place a higher load to your main rotor. This increased load will

reduce the head speed, and in more demanding maneuvers this change can be significant. By

mixing Aileron to Throttle and Elevator to Throttle, you can help compensate the increased load.

This should only be done after properly adjusting your throttle and pitch curves to achieve a

nearly constant head speed throughout your pitch range.

The RaptorTechnique* website has a great tutorial on how to set this up:

http://www.raptortechnique.com/throttlemix.htm

Link a Channel to Your 7

This just links one channel to another. You choose a upper and lower percentage, and that will

effect how much the two channels correlate. This will give you indirect proportional control over

your 7

and 8

*RaptorTechnique.com is not affiliated with Airtronics or Global Hobby Distributors.

or 8

Channel.

channels if so desired.