Auburn Gear Power Wheel Model 5 Посібник з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Мікрофонна система Auburn Gear Power Wheel Model 5. Auburn Gear Power Wheel Model 5 4 сторінки. Single reduction shaft and spindle output drives
Друкувати сторінкуIMPORTANT: All Power Wheel units and kits are shipped with a nameplate that includes the Auburn Gear part
number and order code as shown.
Power Wheel
ORDER CODE: 6WB13156C
Example:
PART NO.: 6000236
SERIAL NO.: 143434
AUBURN, IN U.S.A.
In addition to the nameplate, Power Wheel drives are stamped with an identification number which appears on the
cover or hub flange as shown.
Example: 6000236-A-4-9
When ordering parts, the information included on the nameplate or the stamped identification number is necessary to
accurately identify the drive and obtain the correct replacement parts. Once this information has been obtained,
contact Auburn Gear for the appropriate parts list.
STEP 1
Remove twelve hex head bolts (18) and washers (17)
from cover (15). Thrust washer (14) usually remains with
cover (15).
STEP 2
Lift sun gear (13) from carrier assembly (12).
STEP 3
Remove carrier assembly (12) from ring gear (11).
STEP 4
Pull ring gear (11) from remaining assembly. N
may be necessary to strike ring gear with a rubber mallet
to loosen from hub.
STEP 1
Press bearing cups (4 & 7) into each side of hub (6). It is
recommended that bearing cups (4 & 7) and cones (3 &
8) be replaced in sets.
STEP 2
Assemble bearing cone (3) into cup (4) at seal end of hub
(6) and press a new seal (2) in until flush with face of hub
(6).
STEP 3
Lubricate lips of oil seal (2) and lower hub (6) onto output
shaft (1). Keep hub (6) centered to prevent damage to oil
seal (2).
STEP 4
Assemble bearing cone (8) over output shaft (1) and into
bearing cup (7). Install thrust washer (9) over output shaft
(1). If bearings (3, 4, 7 & 8), hub (6) or output shaft (1) is
replaced, a new retaining ring (10) is required for proper
IDENTIFICATION
®
DISASSEMBLY OF POWER WHEEL
: It
OTE
ASSEMBLY OF POWER WHEEL
STEP 5
Remove retaining ring (10) from groove in output shaft
(1). Lift thrust washer (9) from assembly. Pull output shaft
(1) from hub (6). N
: To remove retaining ring, use
OTE
retaining ring expander tool.
STEP 6
Remove oil seal (2) and bearing cones (3 & 8) from hub
(6). Inspect bearing cups (4 & 7) in hub (6) and remove
only if replacement is required.
bearing setting. Select the thickest retaining ring (10) that
can be assembled in ring groove of the splined end of
output shaft (1) above bearing cone (8). Bearing should
have from .000 - .006 (.00 - .15mm) end play when
proper retaining ring (10) is installed.
STEP 5
Clean mating surfaces and apply a bead of silicone
sealant to face of hub (6) that mates with ring gear (11).
See instructions on sealant package.
STEP 6
Assemble ring gear (11) to hub (6) being careful to align
all bolt holes.
STEP 7
Place carrier assembly (12) into ring gear (11) aligning
the gear teeth. Carrier splines mesh with splines on
output shaft (1).
2