daltile 1048BRS Посібник з експлуатації - Сторінка 17
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Пила. daltile 1048BRS. daltile 1048BRS 20 сторінок. Professional tile saw
Друкувати сторінкуMAINTENANCE & TROUBLESHOOTING
PROBLEM
The machine does not work.
Water does not flow at the Blade
while the pump is running.
Motor is not running properly.
Pump is not running.
Bad cutting alignment.
CAUSE
The power supply cable is
damaged or not properly con-
nected.
No voltage in the power
outlet.
Start Switch is damaged.
The sprayers are clogged.
The water level in the waterbin
is not sufficient. The pump is not
totally submerged.
Water valve is closed.
Water may have seeped throu-
gh inside the motor.
Capacitor is damaged.
Motor bearing are damaged.
The impeller or suction filter of
the pump is damaged.
No proper connection of the
power cable.
Machine is not level.
Unlevel working surface.
Improper or glazed Diamond
Blade.
DALTOOL 1048BrS OPERATING MANUAL V02/2008R1 PAGE 17
SOLUTION
Press the plug firmly in the
power outlet. Check the power
supply cable.
Have the power outlet
checked.
Have the Switch replaced.
Clean the sprayers
Fill the waterbin with clean
water until the pump is totally
submerged.
Open the valve.
Unplug the power cable and
consult your local dealer.
Unplug the power cable and
consult your local dealer.
Unplug the power cable and
consult your local dealer.
Replace damaged parts.
Have the connection checked.
Loosen the screws for the legs.
Pick up the machine a little bit
on one end. Let the machine
down again nd tighten screws.
Do the same procedure for the
other end. Machine should now
be level
Make sure the machine is pla-
ced on a level surface.
Replace or dress the Diamond
Blade.