Airtronix PV-7 Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Антена Airtronix PV-7. Airtronix PV-7 4 сторінки. Portable multi-band vertical hf antenna
Друкувати сторінкуThat's it. You're DONE ! Now you're ready to work the World on the HF bands with one of the most portable and
efficient antennas available. Be sure to read the "Antenna Use", "Operating Tips" and "Precautions" sections
(below) before actually transmitting with the antenna.
NOTE: Some sway in the antenna and coil is natural (especially on windy days) and will not seriously affect
performance. Disassembly of the antenna is simply performed by reversing the order of the steps above.
Antenna Usage
Once the antenna is correctly assembled, completely erected and connected to a transceiver, you are ready to
operate.
1. If you haven't already, connect the antenna to a transceiver (The Feedpoint Insulator accepts a male
BNC connector -- adapters may be used).
it very secure as it must hold the entire weight of the antenna
upright)
3. Put the lug of the Ground Radials/Counterpoise Wires [D] on
the bolt labeled "Ground" of the Feedpoint Insulator
Assembly [B] and thread it (finger-tight) into the Couple Nut
[H] already attached to the Ground Support Stake (all nuts
should only be tightened with fingers – do not use a wrench
– to avoid damaging the antenna).
4. Thread two Coupling Nuts [H] halfway onto each end of the
remaining Steel Riser [J]
5. Now thread the Steel Riser [J] (with the two Couple Nuts [H]
already attached at each end) onto the bolt labeled
"Antenna" on the Feedpoint Insulator Assembly [B] already
attached to the Support Stake.
6. Tightly connect the 3 PVC Risers [E] together using the 2
PVC Couplers [F] (this will become the inner Coil Support for
the Tuning Coil).
7. Tightly connect the 2 PVC End Caps [G] to the inner Coil
Support – one on each end (top and bottom).
8. Connect the Coil [C] around the inner Coil Support (be
careful not to permanently bend any the coils) and place the
bolts at each end of the inner Coil Support through the holes
at each end of the Coil [C] (this is your Coil Assembly).
9. Connect the Wander Lead [D] lug around the bottom bolt of
the Coil Assembly and then thread the entire Coil Assembly
to the Coupling Nut [H] of the Steel Riser [J] already
attached to the base of the antenna.
10. Thread the Telescopic Whip Antenna Assembly [A] to the
top bold of the Coil Assembly and then fully extend the
telescoping antenna.
11. Extend the Ground Radials/Counterpoise Wires [I] out in
three directions (of equal spacing) from the antenna (120-
degrees apart from each other) and leave them resting
above on the ground.