dams Elev82 Touch EVT-RET Інструкція з монтажу Посібник з монтажу - Сторінка 16

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Внутрішнє оздоблення приміщень dams Elev82 Touch EVT-RET. dams Elev82 Touch EVT-RET 16 сторінок. Return desk

Друкувати сторінку

Step 27

Upgrading to the Digital control unit

Make sure that your height adjustable desk is turned off and unplugged from the mains.

Unplug the controller supplied with your height adjustable desk and replace with the digital

control unit. Fix this to your top using the wood screws provided.

After connecting the digital control unit you will need to perform a reset.

Reset

• Press both up & down buttons at the same time for 3 seconds. Continue pressing the buttons

until both columns are in lowest position. When the reset is finished, the control box makes a

beep and the buttons can be released.

• When conducting reset, the display shows "000" in last 100mm stroke. When the reset hsd

finished, the display shows starting height again.

• If releasing up & down buttons before the display shows "000", the desk goes back to normal

operation.

• Reset is necessary for first operation of the desk.

Normal operation

• Press any button. 3-digits display shows current desk height in centimeters.

• Press up or down button to adjust the desk height.

• When no button has been pressed for 10 seconds, display goes off. Press any button to light

up the display again.

• When no button has been pressed for 30 seconds, the system goes to <0.1 W standby mode.

Long press any button to wake the system up. Display shows desk height again.

Memory position

The digital control unit supports 4 memory positions. to set the positions follow these steps;

1. Operate the desk to preferred height.

2. Press any of 1,2,3,4 buttons together with up or down buttons for 2 seconds to store the

current height. Display shows P1/P2/P3/P4 when the position has been stored.

3. Now, hold any of the 1,2,3 or 4 buttons until the desk reaches the stored height.

Stored postion can only be overwritten, not to be cleared.