dams EVMB-1200 Інструкція з монтажу Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Внутрішнє оздоблення приміщень dams EVMB-1200. dams EVMB-1200 9 сторінок. Back-to-back desks
Друкувати сторінку
14
Step 14
Finally attach the desktop
controller to the underside of
the desktop using the wood
screws provided. If you are using
a cordless/power driver make
sure it is on a low torque setting.
There are pre-drilled holes on
either side of the top so the
controller can be attached to the
Left or Right of the desk.
15
Step 15
Your desk is now ready to be connected to the mains outlet.
Before you proceed with operating your new desk it is recommended that you perform a full
reset of the controller to calibrate the height of each leg.
This can be done using the following steps;
Press button down for 3 seconds.
•
Continue pressing the button until both columns are in lowest position.
•
Keep pressing the button until control box makes 1 beep.
•
When control box makes 1 beep, it is confirmed that reset has been completed and button
•
can be released.
Now the desk is operational.
•
If the desk is disconnected by accidently pulling out the plugs at the control box, motors,
•
handset, main power source
or system status reach overload, overheat etc. then the desk must be reset.
•
If the desk is powered off intentionally at the main power switch, then the desk does not
•
need to be reset.
Operating the desk
Press the button, to operate the desk for upwards running.
Press the button, to operate the desk for downwards running.
NOTE
Use Ø4 x 25mm wood screws to
attach the controller to the top.