ADDER AdderLink Infinity 2112T Посібник із швидкого старту - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Подовжувач ADDER AdderLink Infinity 2112T. ADDER AdderLink Infinity 2112T 4 сторінки. Adderlink infinity
Друкувати сторінку
Browser-based configuration utility
To use the browser-based configuration utility, link a computer via
a network switch to the Infinity port of the ALIF unit using a Gigabit
Ethernet connection. This configuration utility allows you to perform
all of the following functions:
• View/edit the IP network address and netmask,
• Configure separate IP network addresses for video, audio and USB,
• Configure video bandwidth settings (on TX units),
• View the current video output (on TX units),
• Perform a firmware upgrade,
• Perform a factory reset.
To access the browser-based configuration utility
1 Connect the Infinity unit and a computer via a network.
2 Run a web browser on your computer and enter the IP address of
the Infinity unit, e.g. http://169.254.1.33
The default settings for the ALIF 2112T are as follows:
• TX unit - IP address: 169.254.1.33 Netmask: 255.255.255.0
Notes:
Where the address of a unit is not known, perform a manual
factory reset (see page 2) to restore the default address.
Your computer must be on the same subnet as the ALIF 2112T
unit.
TX (transmitter) unit configuration
In the ALIF system, the most important configuration details are
dictated by RX units. Thus, the TX unit setup is concerned only with
three main factors:
• Its IP address,
• The data streams to enable/disable, and
• Video signal optimization.
In a Gigabit Ethernet network with sufficient bandwidth, changes
to the Video Configuration page should not be necessary. If
adjustments are required, please see the AdderLink Infinity 2112T
full user guide for details.
For VNC port configuration, please see the rear page