Dan D'Agostino classic stereo Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Dan D'Agostino classic stereo. Dan D'Agostino classic stereo 14 сторінок.

12-volt trigger input/output

These 3.5mm jacks allow the amplifier to be turned on or off automatically by a preamp or

other device that has a 12-volt trigger output, and also allow the 12-volt trigger output

signal to be relayed to other components (such as a second Classic Stereo amplifier).

To use the 12-volt trigger feature with the Classic Stereo amplifier, connect a cable tipped

with 3.5mm plugs (stereo or mono) to the trigger output of the preamp and the trigger

input of the amplifier. Plug in the amplifier and turn it on. You will notice the power does

not come on. However, when you turn on the preamp, the power amp should also turn on.

If it does not, check the owner's manual or the back panel of the preamp or other device to

make sure it outputs a 12-volt trigger signal. Some preamps require that the 12-volt trigger

output be activated through a control menu; if yours works this way, make sure the trigger

output is activated.

If you want to power up another component (such as another Classic Stereo amplifier)

when this amplifier powers up, connect a cable tipped with 3.5mm plugs (stereo or mono)

from the trigger output of this amplifier to the trigger input of the other component.

RS-232 input

This DB9-type input allows the Classic Stereo amplifier to be controlled by home

automation systems that use RS-232 protocol. Consult your Dan D'Agostino Master Audio

Systems dealer for more information.