DAN DRYER 250-251-254 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Сушарка DAN DRYER 250-251-254. DAN DRYER 250-251-254 10 сторінок. Turbo low noise hand dryer
Друкувати сторінку
INSTALLATION
Make sure the main breaker is turned off. Installation must be carried out by a
qualified person in accordance with standards applicable in the country where
the equipment is to be installed.
Place template against the wall at desired height (see mounting height recommendations)
and mark location of (4) mounting holes and the wire service entry.
Note: If several products are installed in close proximity to each other, the minimum
distance between the products should be 610 mm from the centerline of each product.
1: Remove the two screws in the lower
area of the unit and remove the casing
from its base.
3: Connect supply wires to terminal block
4: Attach mounting plate
securely with four screws
2: Insert the power cord through the inlet
hole.
Connections:
A. Connect LIVE to terminal "L"
B. Connect NEUTRAL to terminal "N"
C. Connect GROUND to terminal " "
5: Replace the casing and fasten with two
screws in the lower area
5