Concept Perugini CT 110 Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Сільськогосподарське обладнання Concept Perugini CT 110. Concept Perugini CT 110 15 сторінок. Flail mowers
Друкувати сторінкуALWAYS MAKE SURE THE TRACTOR IS TURNED OFF, P.T.O
IS DISENGAGED AND MACHINE IS MADE SAFE
Attaching the machine to the Tractor
Concept Perugini Flail toppers can be linked up to any tractor with a category 1
three point linkage.
Read the tractor's instruction manual before attaching attempting to attach the
machine to the tractor.
•
Adjust the width of the tractor arms to match the lower brackets on the
machine
•
On a flat surface reverse the tractor up to the machine
•
Firstly attach the lower links and do the necessary adjustments to limit
sideways movement
•
Lengthen and attach the top link in order to have the machine parallel to the
ground once attached
•
Remember to fit all the locking pins and that the machine is safely secured
to the tractor
PTO Shaft
If necessary, cut the PTO shaft to the right length following the shaft
manufacturer instructions.
When attaching the PTO shaft to the machine and tractor make certain that if the
PTO shaft is fitted with an overrun clutch this must be installed on the implement.
When connecting to the tractor verify that the locking pin is correctly located and
secure in place. Before use make sure all the chains and guards are correctly
fitted.
Working Depth
The height of the machine from the ground is controlled by the rear roller, skids
and top link. Before using the flail mower make sure that the flails do not hit the
ground, this will result in extreme wear will damage the rotor.
Always adjust the top link to keep the machine parallel to the ground when
adjusting the height of the rear roller.
B
8
CT
The working depth is set by altering the
A
position of the rear roller support.
To do this:
Slacken bolt A
•
Remove and reposition the support in B
•
•
Tighten all bolts
•
Repeat for both sides