Elite Acoustics Engineering D6-8 MKII Короткий посібник з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Короткий посібник з експлуатації для Підсилювач Elite Acoustics Engineering D6-8 MKII. Elite Acoustics Engineering D6-8 MKII 10 сторінок. 80w lithium battery powered acoustic amplifier with 6 channels, digital mixer & effects, and bluetooth
Друкувати сторінку
QUICK START MIC AND ACOUSTIC GUITAR
In this example we connect an acoustic guitar to Chan 1, and a
Mic to Chan 2.
1. Set Battery Switch to "Connect"
2. With "Speaker Volume" turned down, Turn "Power Switch" to
"On" position.
3. Connect the Line Level Output of your acoustic guitar into
Chan 1, Line 1/4" input jack. Note: Chan 1 Source is set to
"Mic/Line."
4. Connect your Mic to Chan 2, XLR input jack. Note: Chan 2
Source is set to "Mic/Line."
5. Set input levels. Press "System"; the LCD shows a level bar
graph for each channel. Adjust rear panel "Gain" control until
the display shows -12dB for Guitar and Mic.
5A. Adjust Master Volume for desired output level.
6. Set Mic Mix, EQ, and Reverb.
6A. Press "Main" adjust chan 2 encoder to +9, i.e., approxi-
mately 75% of max level.
6B. Press Chan 2 Encoder: LCD shows EQ parameters for
Chan 2. Adjust 5 encoders as necessary to set your EQ.
For our example we'll set "LowC" to 180 Hz, "Low" to +4.0,
"Mid" to +5, "MidF" to 2.0k and "Hi" to +2.0.
6C. Press "Reverb" Chan 2 encoder +2.0.
7. Repeat step 6 for Chan 1 (acoustic guitar) Mix, EQ, and Re-
verb.
8. Start with master EQ, Low, Mid, and High set flat (detent
position) and adjust as needed.