Anybus X-gateway CANopen Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Блок управління Anybus X-gateway CANopen. Anybus X-gateway CANopen 2 сторінки.

Друкувати сторінку
Installation Sheet
Module Front
LED Ind.
Communication Status
1
Link/Activity
3
5
CANopen Subnet Status
LED Indicators
LED no
Indication
1 (Communication
Off
Status)
Green
Flashing green
2 (Module status)
Off
Green
Single flash, green
Double flash, green
Single flash, red
Triple flash, red
Quadruple flash, red
3 (Link/Activitiy)
Off
Green<
Flashing green
4 (not used)
-
5 (CANopen
See Anybus X-gateway CANopen installation sheet
Subnet Status)
6 (Device Status)
See Anybus X-gateway CANopen installation sheet
Dec 2010
Module Status
2
(not used)
4
6
Device Status
Profinet Connector
Meaning
No power or not online
Online, connection with IO estab-
lished, IO controller in run state
Online, connection with IO estab-
lished, IO controller in stop state
No power or module initialized
Module initialized, no errors
Diagnostic available
Used by engineering tool to identify
the module
Configuration error
No station name or no IP address
assigned
Failed to initialize PROFINET IO
object or no MAC address
No link
Link established
Packet is recieved or transmitted
online: www.anybus.com
Anybus X-gateway PROFINET
Network Access Port
Pin no
1
2
3
6
1
8
4, 5, 7, 8
Note: All nodes in a PROFINET network have
to share chassis ground connection. To ensure
this, pins 4, 5, 7 and 8 have to be connected
to the chassis ground.
Accessories Checklist
The following items are required for installation:
•
PROFINET configuration tool (not included)
•
Suitable LAN cable (not included)
•
GSDML file, available at www.anybus.com
Installation and Startup Summary:
•
Restart the module after the CANopen interface has been config-
ured.
•
Connect the gateway to the PROFINET network.
•
Install the GSDML file in the PROFINET configuration tool
•
Power up and (if required) configure the module
Description
TD+
TD-
RD+
RD-
Connect to chassis ground (PE)
SP1197, rev. 1.01