AnyCubic 89590 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для 3D-принтери AnyCubic 89590. AnyCubic 89590 10 сторінок.

3.There are two cases for washing:

Case 1: The printed objects are on the platform. Then

please use the platform holder to secure the platform

as shown below.

Tighten the platform securing knob

Choose the suitable platform holder:

①Adjustable platform holder - Suitable for model

with height less than 115mm.

②Platform holder - Suitable for models with height

greater than 115mm and less than 165mm.

If you use another platform holder, you just need to

ﬁx it directly to the machine.

The height of adjustable platform

holder can be adjusted after loosen

this black knob. Please tighten the

knob after adjustment

Tip: the washing liquid can be alcohol, detergent solution, etc.

Case 2: The printed objects has been removed from the

platform (suitable for small models). Then please use

the washing basket to hold the printed objects.

Note: The holes on the washing basket is 18mm. If the

objects are less than 18mm, please do not remove them

from the platform, and refer to the instructions on the left

to clean them with the platform.

The washing liquid

shall not exceed the

maximum scale