DUCATIHOME 8500V-Rol/ DUCATI UP 70 (CTH29E) Інструкція з монтажу Посібник з монтажу - Сторінка 14
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Відкривач гаражних дверей DUCATIHOME 8500V-Rol/ DUCATI UP 70 (CTH29E). DUCATIHOME 8500V-Rol/ DUCATI UP 70 (CTH29E) 19 сторінок. Garage door automation system 70 kg
Друкувати сторінку9. Adjusting the mechanical end-of-travel stop
Open the door manually to the desired maximum opening position.
At the car's position on the rail, fix the mechanical end-of-travel stop as shown in the following drawings.
Important: tighten securely so that the end-of-travel stop does not move. When the end-of-travel stop is
correctly positioned, tighten the small central set screw (figs. 40-41).
When you operate your automation system, the door will close when the car touches and presses on the
open position end-of-travel stop.
end of travel
Fig. 39
car
10. 230V power supply connection
IMPORTANT: before operating the door electrically ALWAYS ensure that the mechanical components, the
car and the anchor plate (see page 13) are engaged. The door must be in neither the open nor the closed
position.
Remove the plastic cover as shown in Figs. 42-43
Connect the 230 V 50/60 Hz power supply cable to the terminal located on the transformer.
See Fig. 44-45-46
A protection fuse is installed to protect the circuit board and the system. For your safety, it is essential to
use a cable clamp positioned where the cable passes through the hole in the steel plate supporting the
motor. See Fig. 46
IMPORTANT. DANGER: the 230V high voltage connection must
only be performed by a certified professional electrician.
Fig. 42
Fig. 44
motor
transformer
Page 14
Fig. 40
end-of-travel stop
cover
230V
rail
Fig. 43
Fig. 45
Protection fuse
5x20mm 1AT fast
Fig. 41
tighten securely
end-of-travel stop
Fig. 46
230V
cable clamp