DUCTMATE REPEATER 4200 Посібник з експлуатації та технічного обслуговування - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з експлуатації та технічного обслуговування для Електроінструмент DUCTMATE REPEATER 4200. DUCTMATE REPEATER 4200 12 сторінок.
Друкувати сторінкуL U B R I C A T I O N A N D M A I N T E N A N C E
•
Use Pneumatic tool oil or a non-detergent oil. Do not use detergent oil or additives as they will damage o-rings
and rubber parts.
•
Use a filter and regulator when possible.
•
Add pneumatic oil into the air inlet twice daily (depending on frequency of tool use).
•
Wipe tool clean daily and inspect for wear. Use solvents only if necessary - Do Not Soak (solvents may damage
o-rings and other tool parts).
•
Drain compressor tanks and hosed daily.
•
Clean magazine, pusher, and contact trip mechanism periodically.
•
All screws, nuts and fasteners should be kept tight and undamaged. Loose screws results in unsafe operation
and parts breakage.
A C T U A T I O N T O O L
WARNING: Always wear eye and hearing protection when operating tool.
Sequential Fire Trigger (Gray Color)
•
To be used in applications where precise fastener placement is preferred.
•
This trigger reduces the chances of double firing and unintentional firing.
1.
With your finger off the trigger, press the safety nose all the way down on the surface of the material the
fastener is being driven into.
2.
Pull the trigger firing a fastener into the material.
3.
The tool will not fire again until the trigger is released and the safety nose removed completely from the
material being used.
4.
To fire the next fastener repeat the above steps.
5.