AnyTone AT-D269 Посібник з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Двостороннє радіо AnyTone AT-D269. AnyTone AT-D269 17 сторінок. Digital dmr and analog vhf/uhf two way radio

Друкувати сторінку

radio will switch to the transmitter state, and the mouth will speak with a

normal tone 2.5~5cm into the microphone to answer the call.

Note:Users can edit the group call prompt tone and individual call prompt

tone through the PC software.

Make a call

3.6

※ Select the pre-programmed channel to initiate a call

(1) Rotate the band switch in standby mode to select the relevant pre-

programmed channel, including frequency, channel type (digital or analog),

contact, call type (single call/group call/all call), etc.

(2) Keep a distance of 2.5~5 cm between your mouth and the radio

(3) Press and hold the [PTT] key, the red LED indicator will light up in this

state, if the radio has a programmed call tone, after the radio sends a call

tone, speak with a normal tone.

(4) Release the [PTT] key to wait for the receiver to answer.

Note:When the call hold time is not reached after the call is over, press the

PTT button again to call again.When the call hold time arrives, the current

channel will return to the pre-programmed call contact.

Monitor

3.7

Press and hold the [PF2] key in the standby state to enter the monitoring

state. When the radio receives a valid carrier but the signaling or ID does

not match or the signal is weak and cannot be successfully decoded, this

function can be used to monitor. After releasing this key,the radio will turn

off the speaker and return to standby.

Note:If no signal is received and on an analog channel, press and hold this

key to emit noise. Press and hold this key in digital channel without sound.

Battery level query

3.8

In the standby state, press the [PF1] button, the radio will broadcast the

current battery level in the form of voice prompts.

Alarm function

3.9

Press and hold the [Top] key to activate the alarm function, and press this

key in the alarm state to exit the alarm function.

Note:Combined with the emergency alarm setting of PC software, a

variety of alarm modes can be realized.

AT-D269 Digital DMR and Analog VHF/UHF Two Way Radio

3. BASIC OPERATIONS