AnyTone AT6200 GW Посібник з монтажу - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник з монтажу для Ретранслятор AnyTone AT6200 GW. AnyTone AT6200 GW 19 сторінок. Mobile signal repeater

AnyTone AT6200 GW Посібник з монтажу
improve coverage.
- Check if it is necessary to adjust the direction of the indoor antenna.
- Check whether it is necessary to add one or more antennas to enhance the coverage in special areas.
Remark:
Reduce attenuation values * — by ensuring the isolation level
Increase output power * — recommended ways: to adjust outdoor antenna direction/location, or replace it to an
antenna with higher gain to increase input signal strength.
7.4.2. Repeater can not communicate in Power-ON status
1. The power is on but there is a signal fluctuation or a flash signal. The phone call cannot be made/received.
It shall be caused by the insufficient isolation between outdoor and indoor antennas.
Please take the following measures:
- Firstly check whether the alarm LED lights. Compare with the description from the 7.3. section The light may indicate
the isolation is insufficient.
- Secondly adjust the antennas' directions or locations or enlarge distance between them.
- Thirdly reduce the repeater's gain by ATT DIP if the above listed methods don't work.
The following measures can also be helpful:
- Use the roof of the building to enlarge isolation (Please try to place the outdoor antenna and indoor antenna on
different floors).
- Use some obstacles (Such as walls).
2. The repeater's power is on but the phone cannot get connected to the network and still can not communicate.
Reason 1: There are loose or wrong connections in the repeater system.
Solution: Please try to fasten the connections between different parts of the system.