Dudoff London BB-Z01 Посібник з монтажу та інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з монтажу та інструкція з експлуатації для гриль Dudoff London BB-Z01. Dudoff London BB-Z01 12 сторінок. Built-in electric barbecue

Друкувати сторінку

5) ELECTRICAL CONNECTIONS

IMPORTANT: the appliance must be

installed following the manufacturer's

instructions. The manufacturer will not be

liable for injury to persons or animals or

property damage caused by an incorrect

installation.

The electrical connection must be made in

conformity with current rules and regulations.

Before making a connection, check that:

- the voltage matches the value shown on the

specification plate and the section of the wires of

the electrical system can support the load, which

is also indicated on the specification plate.

- The capacity and outlets of the electrical

installation are suitable for the maximum power

output of the appliance (see the information label

attached on the underside of the housing).

- The outlet or installation is provided with a ground

connection according to standards and provisions

currently in force. All responsibility is declined for

failure to comply with these provisions.

- If a power cord is not supplied with the appliance,

connect a cable with a suitable section to the

terminal board (see the table in paragraph 6)

keeping the ground wire longer than the lead

wires in conformity with the diagram in fig. 7.

When connection to the power circuit is made

through an outlet:

- apply to power cable "C", if not provided, a

standard plug suitable for the load indicated on

the information label. Connect the wires as in the

diagram in fig. 7 taking care to observe the

responses listed below:

letter L (phase) = brown cable;

letter N (neutral) = blue cable;

symbol

(earth) = yellow-green cable.

- The power cord must be placed in a way that it

does not reach an temperature of 90 °C in any

position.

- To connect, do not use adaptors or switches as

they may cause false contacts resulting in

dangerous overheating.

- The outlet must be accessible after the built-in.

INSTALLATION

When connection is made directly to the power

circuit:

- place a switch between the appliance and the

circuit of an appropriate size for the load of the

appliance and with a minimum aperture between

contacts of 3 mm.

- Remember that the earth cable must not be

broken by the switch.

- The electrical connection may also be protected

by a high sensitivity differential switch.

It is strongly recommended that the yellow-green

earth cable provided be connected to a good earth

installation.

Before performing any service on the electrical

part of the appliance, it must absolutely be

disconnected from the electrical network.

If the installation requires modifications to

the home's electrical system or if the

socket is incompatible with the appliance's

plug, have changes or replacements

performed by professionally-qualified

person. In particular, this person must also

make sure that the section of the wires of

the socket is suitable for the power

absorbed by the appliance.

WARNINGS:

all our products are conform with the European

Norms and relative amendments. The product

is therefore conform with the requirements of

the European Directives

in force relating to:

- compatibility electromagnetic (EMC);

- electrical security (LVD);

- restriction of use of certain hazardous

substances (RoHS);

- EcoDesign (ERP).

FIG. 7