Anywire ARW-03 Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Привід Blu-ray Anywire ARW-03. Anywire ARW-03 17 сторінок. Address writer
Також для Anywire ARW-03: Посібник з експлуатації системи (6 сторінок)
Друкувати сторінку[Address reading...READ Mode]
This is the mode to read the addresses written in a unit.
Check that power (in the case of 2-wire type, transmission signal) is supplied to the reading target unit.
■Address reading operation
How to operate
1
Turn ON the POWER switch.
2
Press the SELECT switch.
Press the SELECT switch
several times to
3
light the READ display.
4
Press the SET switch.
Point the light emitting and
receiving part (yellow frame)
5
at the address setting port of
the unit to be written and
then press the SET switch.
When moving to the next unit
to read addresses,
directly move to the next
6
address setting port to press
the SET switch and repeat reading.
7
In the case of failure in reading
Readjust the light emitting and
8
receiving part and
press the SET switch again.
- Clear the Err display.
- Switch the mode to another mode.
9
Press the CLEAR switch.
Press the SELECT switch
10
several times to light the display of
a desired mode.
11
Press the SET switch.
After using ARW-03, keep the POWER switch
pressed to turn OFF the power.
READ (green)
Example)
Example)
Example)
READ (green)
WRITE (yellow)
DIRECT WRITE (orange)
-ARW03 8/17-
Display
After approximately
2 seconds,
"SELECt" flashes.
----Flashing
The reading mode is
determined.
During the reading
operation
Address values read
During the reading
operation
Address values read
Err display
During the reading
operation
Address values read
Return to the reading
mode display
READ must be lighted.
Light emitting and
receiving part (yellow frame)