Danby DDW2405BL Інструкція з монтажу Посібник з монтажу - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Посудомийна машина Danby DDW2405BL. Danby DDW2405BL 13 сторінок. Built-in
Також для Danby DDW2405BL: Інструкція з монтажу Посібник з монтажу (13 сторінок)
Друкувати сторінку
PREPARE HOT WATER LINE:
• The hot water line may enter from either side, rear or
floor within the shaded area shown in Fig. 6
• The line may pass through the same hole as the
electrical cable and drain hose. Or, cut an additional
1-1/2" dia. hole to accommodate the water line.
WATER LINE CONNECTION:
• Turn off the water supply.
• Install a hand shut-off valve in an accessible location,
such as under the sink.
• The water connection is located on the left front side of
the dishwasher. Install the hot water inlet line, using a
braided flexible hose (available at most hardware
stores). Route the line as shown in Fig. 6 and extend it
forward at least 18" from the rear wall.
• Adjust water tank (heater) for 120 F to 150 F (49C to
65.5C) temperature.
• Flush water line to clean out debris.
• The hot water supply line pressure must be 20 ~ 120psi
CAUTION:
DO NOT OPEN THE DOOR UNTIL
YOU ARE READY TO INSTALL
THE DISHWASHER.
Opening the door will cause the dishwasher to tip forward.
If it is necessary to open the door, hold the top of the
dishwasher securely with one hand and hold the door with
the other hand.
INSTALLATION INSTRUCTIONS
STOP
BEFORE YOU BEGIN
Locate and set aside the package containing the
2 Phillips Head Countertop Mounting Screws.
STEP 1
CHECK DOOR BALANCE
To check the door balance, hold the top of the dish-
washer firmly.
• Open the door slowly, if the door drops when
released, increase spring tension. If the door
closes when released, decrease spring tension.
• Pull the spring adjustment pin out of the holes,
insert into the next highest or lowest hole and
test again.
• Adjust both door springs to the same tension.
• Continue moving the spring pin until the door
is balanced.
4