Duerkopp Adler 559 Інструкція з монтажу Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Швейна машина Duerkopp Adler 559. Duerkopp Adler 559 20 сторінок. Automatic single-chainstitch eyelet machine
Друкувати сторінку
4.
Lifting eye bolt
8
5.
Assembly of the main switch
5
4
3
The lifting eye bolt helps you to lift the automat into the stand. For
example you can hoist the automat by a ceiling crane or you put a rigid
bar (e.g. the bar of the thread stand) through the lifting eye bolt and lift
the automat with 2 persons. The lifting eye bolt is included in the
accessories.
–
Screw the lifting eye bolt 8 on the automat.
–
Lift the automat into the stand.
–
Unscrew the lifting eye bolt 8 when the automat is mounted.
6
–
Loosen the screw 4 and remove the switching knob 5.
–
Remove the main switch cover.
For this purpose, unlock the tab in the hole 6.
–
Insert the cable from the control box in the main switch.
–
Connect the cable cores of the control box to the terminals
L1 (1à brown) and L2 (2 à blue).
Connect the protective earth (3 à yellow-green) of the control box
to the main switch too.
–
Make sure that the notch 7 of the main switch faces down.
–
Put the main switch cover again. Put on the switching knob 5 and
screw it tight.
Hint
If you manufacture the table top yourself, fit the main switch at
an easily accessible place because the main switch is also the
emergency stop switch.
1
2
7
2
5