Duerkopp Adler 739 Інструкція з монтажу та перелік запасних частин - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з монтажу та перелік запасних частин для Швейна машина Duerkopp Adler 739. Duerkopp Adler 739 12 сторінок.
Друкувати сторінку
3.9 Commissioning
2-12
After the installation is completed, configure the control system of the
sewing machine and carry out a sewing text at a low rotating speed.
–
Plug in power supply.
Caution risk of injury!
Switch off main switch.
Never insert the needle thread or bobbin thread while the main switch
is on.
–
Insert needle thread (see operating instructions).
–
Insert bobbin thread (see operating instructions).
–
Switch on main switch.
The control system is initialised.
The sewing unit must now be adjusted to a reference point.
The following display indicates that a reference run must be carried
out.
–
Press the "OK" key.
The reference run is carried out.
After successful referencing the display changes to:
–
After 0.5 seconds, the machine programme changes to operating
mode.
–
Insert material in material clamp.
–
Position material clamp onto the guide.
–
Press "S".
The sewing operation is started.
–
Check whether the seams conform to the set requirements.