3onedata ECU100M-2GT1GF Посібник зі швидкого встановлення - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Стелажі та підставки 3onedata ECU100M-2GT1GF. 3onedata ECU100M-2GT1GF 5 сторінок. Industrial multi-service rack

Друкувати сторінку

Daughter card



Note:

Here take Model V as the example of daughter card size,

other daughter cards have the same size.

Management card



Note Before Mounting:

Don't place or install the device in area near water or



moist, keep the relative humidity of the device

surrounding between 5%~95% without condensation.

Before power on, first confirm the supported power



supply specification to avoid over-voltage damaging the

device.

The device surface temperature is high after running;



please don't directly contact to avoid scalding.

【Rack-mounted】

Step 1

Select the device mounting location to ensure

enough size.

Step 2

Place the device on the rack surface plate; adopt 4

screws to mount the right and left mounting lugs on

the rack.

Step 3

Check and confirm the product is mounted firmly on

the rack, mounting ends.

【Disassembling Rack】

Step 1

Device power off.

Step 2

Unscrew the fixed mounting lug screw on the rack.

Step 3

Shift out the device from rack, disassembling ends.

【Power Supply Connection】

AC power supply



The rack has built-in professional communication

power supply, which supports dual power supply

redundancy. When one of the power supplies fails,

it could switch to another one immediately to ensure the

device power supply is not interrupted. Power supply range:

85~264VAC/DC.

【DIP Switch Settings】

The motherboard of management card provides 4

pins DIP switch for function settings, where "ON"

is enable valid terminal. DIP switches definition as

follows:

DIP

Definition

Operation

―

Reserved

Restore

Set the DIP switch to ON, power

factory

on the device again, it will restore

defaults

to factory settings, then turn off

the DIP switch.

Set the DIP switch to ON,

Upgrade

upgrade the device, then put the

DIP switch back.

―

Reserved

Managed/unmanaged daughter card provides

4-pin DIP switch for function setting. where "ON"

is enable valid terminal. The device needs to be

powered on again to change the status of DIP switch. DIP

switches definition as follows:

DIP

ON Status

OFF Status

Managed daughter



card: reserved

Unmanaged daughter



card: enable LFP

Managed daughter

card: reserved

Unmanaged

daughter

card: