Cascade 90FX Інструкція з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Навантажувачі Cascade 90FX. Cascade 90FX 14 сторінок. Swing frame paper roll clamp

Друкувати сторінку

NSTALLATION

Truck Preparation

NOTE: Prior to installing the 90FX Paper Roll Clamp,

install the following components on the truck:

• Solenoid-operated 3N2 control valve in the CLAMP

and ROTATE supply lines to the Attachment.

• 'Tee' adapter in the truck tank main return line for

return-to-tank from the 3N2 Control Valve.

Install 'Tee' adapter

Determine a suitable location and install the

'tee' adapter in the truck tank main return line.

CAUTION: Do not install into power steering

or other tank return lines.

Mount 3N2 Control Valve

Determine a suitable mounting location for the

solenoid-operated control valve. If mounted on

the truck cowl as shown, the valve must not

extend outside the width of the cowl or interfere

with the truck mast when tilted back.

If the valve is mounted in the engine compart-

ment, make sure it is securely mounted. Use

hose clamps or cable ties as necessary.

NOTE: Control valve ports are drilled straight-

through allowing 'tee' connections when opposite

ports are capped. Straight-through connections

are preferred to reduce entrapped air and enable

use of straight fittings.

From truck

auxiliary

valve block

Push-On Fitting

From Control

Tank Return

Valve TANK port

Hose

Valve must not

extend outside

width of cowl.

'Tee' fitting

AC0150.ill

To truck tank

Check for

interference

with mast

tilted back.

RC1301.ill

6028021 Rev. 1