Aobosi CLS55 Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник Aobosi CLS55. Aobosi CLS55 13 сторінок. Car refrigerator
Друкувати сторінку
6.FUNCTION AND OPERATION
TEMPERATURE CONTROL
• Power Supply： connect to 12V/24V DC or 100~240V AC power(using dedicated adapter).
• Display Screen Initialization： connect to the power supply, the buzzer will make a long
beep, and the display will be on for 1 second then enter the normal operating mode.
• Power ON/OFF： press
• Left/Right Compartment Setting： under the running state, long press
time for 3 seconds to switch ON/OFF the left compartment, long press
time for 3 seconds to switch ON/OFF the right compartment, two compartments cannot
be switched off at the same time.
• Temperature Setting: press
/right compartment temperature setting. Press
The setting will be saved after stop operating for four seconds, the temperature displayed
is the current temperature of the compartments, it' ll take a while to reach the set
temperature. Temperature setting range: -20~20°C （-4~68°F）
• Cooling Mode： under the running state, press
(energy saving mode).(*Factory setting is HH.)
• Battery Protection Mode： under the running state, long press
screen flashes, then press
Voltage Reference:
INPUT
MODE
L
M
H
* the voltage is theoretical value, there may be a deviation in different sceneries.
Due to the different output voltages between vehicles, H should be set when the product
is connected to car power, and M or L should be set when it is connected to a portable
battery or other back-up battery.
• Temperature Unit Setting： switch off the fridge, long press
displays, then switch to E5 by pressing
Celsius or Fahrenheit.(*Factory set
LEFT COMPARTMENT
to switch ON/OFF.
or
, the left screen will flash, then press
again to switch High, Medium and Low (*Factory setting is High).
From left to right: Low/Medium/High.
DC 12V
CUT OUT
8.5V
10.1V
11.1V
SET
L
R
RIGHT COMPARTMENT
or
to adjust the temperature.
to switch HH(fast cooling mode) or Eco
CUT IN
CUT OUT
10.9V
11.4V
12.4V
again. Under E5 mode, press
ON/OFF
and
and
to switch left
for 3 seconds until the left
DC 24V
CUT IN
22.7V
21.3V
22.3V
23.7V
24.3V
25.7V
for three seconds until E1
or
to select
at the same
at the same