Addictive audio F300.4 Посібник користувача та інструкція зі встановлення - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача та інструкція зі встановлення для Підсилювач Addictive audio F300.4. Addictive audio F300.4 15 сторінок. Fleck series amplifiers

Друкувати сторінку

Power Supply Connections

The +12VDC and GROUND wires should be heavy gauge copper wire with heavy

insulation and of the same gauge. Please see the chart below for recommended

gauge and fuse.

F300.4

F300.1

In addition, it has a 12V remote control wire and it should be 14AWG-18AWG.

It is preferable to have longer speaker wires and shorter power supply wires to

minimize power losses.

+12V Power (+12V)

This wire is usually connected directly to the positive battery terminal. Be sure to

use proper fuse as rated above within 16 inches of the main battery.

(Refer to Fig. 1)

Ground (GND)

This connection must be completed using an "O" ring (to prevent coming loose)

with insulating sleeve. This wire is the electrical ground and must be fastened

securely to the vehicle chassis. The best method is to use threading sheet metal

screw(s) since the threads cut into bare metal. Ensure that all paint coating or

other insulation is removed from around the ground area. Use as short of a piece

of cable as possible –

Remote (REM)

Many source units (cd player) or other music sources have an output terminal for

connection of the remote turn-on of the power amplifier. If the source unit doesn't

have a remote turn-on feature, then you can connect the remote wire to a switch

that derives power from an ignition switched circuit.

First make +12V wire connection then the ground connection and finally the

remote connection.

battery for protection against possible damage. If you need to replace the power

fuse, replace it with a fuse of the same value. Using a fuse of a different type or

rating may result in a serious hazard.

60 AMP FUSE

Same gauge as +12V and no longer than 36"

Again, use the same gauge as the +12V.

Furthermore the +12V wire must always be fused at the

(Refer to Fig. 1)

Caution

8 GAUGE

(Refer to Fig. 1)