Danfoss VLT Soft Starter MCD 600 Посібник з монтажу
Переглянути онлайн або завантажити pdf Посібник з монтажу для Контролер Danfoss VLT Soft Starter MCD 600. Danfoss VLT Soft Starter MCD 600 2 сторінки. Modbus rtu card
Також для Danfoss VLT Soft Starter MCD 600: Посібник з монтажу (20 сторінок), Посібник з монтажу (20 сторінок)
Друкувати сторінку
Installation Guide
Finger Guards
VLT® Soft Starter MCD 600
1 Description
1.1 Introduction
SHOCK HAZARD
The soft starter contains dangerous voltages when connected to mains voltage. Attaching or removing accessories when the soft
starter is connected to mains may cause death or serious injury.
-
Isolate the soft starter from mains voltage before attaching or removing accessories.
-
Fit finger guards to all terminals, even if no cable is connected.
Finger guards fit over the soft starter's power terminals to increase IP rating and prevent accidental contact with live terminals.
Finger guards provide IP20 protection when used with cables of diameter 22 mm or greater.
1.2 Parts List
Item
Finger guard
Retaining brackets
Cable ties
Installation guide
Table 1: Code Number
Kit
Finger guard kit IP20, models 0144B–0579B and 0160C~0448C
Finger guard kit, models 0654B–1250B
Finger guards are not available for models 0590C–1134C.
Danfoss A/S © 2021.08
W A R N I N G
N O T I C E
Quantity
6
6
6
1
Ordering number
175G0186
175G0202
AN265232178649en-000201 / 175R1176 | 1