Dunavox DAU-20.58SS Інструкція з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Охолоджувач для вина Dunavox DAU-20.58SS. Dunavox DAU-20.58SS 16 сторінок.
Друкувати сторінку
Key Lock (Only for models with outside controls)
After 2 minutes or longer without pressing any key,
the key lock will be activated automatically. To
remove the lock, press the UP and DOWN keys at
the same time for at least 5 seconds and the
indicator light will flash three times to confirm the
action.
Setting the Temperature Control
The unit has single temperature zone. The
temperature can be set between 5ºC and 22ºC
(41ºF and 72ºF) which is ideal for storing red,
white or sparkling wine.
When the unit is plugged in for the first time, the
unit will power up automatically to the preset
defaults. The temperature preset at the factory
is 12°C (54ºF).
You can set the temperature as required by
pressing the UP or DOWN key. When you
press the two keys at the first time, the display
will show the last temperature set previously.
The temperature will increase 1°C/1ºF if you
press the UP key once, or the temperature will
decrease 1°C/1ºF if you press the DOWN key
once. The display flashes while you make the
setting.
After the temperature has been set, the display
shows the current inner temperature.
To view the set temperature at any time, press
the UP or DOWN key, the set temperature will
temporarily flash in the display for 5 seconds.
Then the display shows the current inner
temperature again.
USE AND CONTROL – DUAL ZONE
The Controls of Your Unit
POWER
To turn the appliance on/off, press and hold the
key for 5 seconds until themperature display lights
up or goes out.
NOTE: Pressing the
audible alarm when the alarm is on.
UP
To increase (warm) the set temperature by 1°C or
1ºF.
DOWN
To decrease (cool) the set temperature by 1°C or
1ºF.
LIGHT
Used to turn the inner light on/off.
key once can switch off the
Display
Display
the
digital
indicators.
is for UPPER temperature zone and
LOWER temperature zone.
is for LEFT temperature zone and
temperature zone.
Indicator Light
The indicator light is located at the right lower corner
of the display. The indicator light will be on when the
multi-key function is selected. To perform the multi-
key function, press and hold the first key, then press
the rest key for at least 5 seconds and then release
all the keys.
ºF/ºC Selector
Select the temperature display setting in Fahrenheit
or Celsius degree. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit,
press and hold the LIGHT key for 5 seconds.
Key Lock (Only for models with outside controls)
If in 2 minutes or longer without touching any key,
the key lock will be activated automatically. To
remove the lock, press the UP and DOWN keys at
the same time for at least 5 seconds and the
indicator light will flash three times to confirm the
action.
Setting the Temperature Control
The unit has two separate temperature zones.
The temperature of both zones can be set
between +5ºC and +22ºC (41ºF and 72ºF). The
LOWER/RIGHT temperature zone is ideal for
storing white and red wine at a setting of +13°C
to +22°C (55°F to 72°F). The UPPER/LEFT
temperature
champagne and white wine at a setting of +5°C
to +13°C (41°F to 55°F).
When the unit is plugged in for the first time, the
unit will power up automatically to the preset
defaults. The preset temperature at the factory
for UPPER/LEFT temperature zone is +10ºC
(50ºF) and for LOWER/RIGHT temperature
zone is +16ºC (60ºF).
You can press the left side UP and DOWN keys
to control the internal temperature of the
UPPER/LEFT temperature zone and press the
right side UP and DOWN keys to control the
internal temperature of the LOWER/RIGHT
temperature zone. When you press the two
keys at the first time, the display will show the
last temperature set previously.
IMPORTANT: The temperature set for the
LOWER temperature zone must always be
higher than that in the UPPER temperature
zone.
For
temperature of the two zones should differ by at
least 4°C.
9
temperature
and
is for RIGHT
zone
is
suitable
for
optimal
performance,
service
is for
storing
the
set