AOK TX2056A Посібник - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник для Метеостанція AOK TX2056A. AOK TX2056A 18 сторінок. Rc weather station with bbq weather display and outdoor sensor
Друкувати сторінкуInitial setup
Follow the instructions in the order described and first put the batteries in the wireless sensor. This is the
only way for the weather station to function without any problems.
the device on.
Wireless sensor
1. Remove the battery compartment cover on the back of the wireless sensor.
2. Insert 2 LR6 (AA) / 1.5 V batteries facing in the direction indicated on the bottom of the battery
compartment. Make sure that the poles of the batteries are correct (+/-). As soon as the wireless sensor is
receiving power, the red pilot light will light up and thus display that data is being transmitted to the base
unit.
3. Put the battery compartment cover back in place.
- Do not use batteries that have a voltage that is too low (only 1.2 V instead of 1.5 V). This affects the
accuracy of the measurements, among other things.
- If possible, use alkaline batteries instead of zinc-carbon batteries. Alkaline batteries last longer,
particularly outside in low temperatures.
Using additional wireless sensors
The weather station comes with one wireless sensor. However, you can operate the weather station with up
to three wireless sensors.
• The wireless sensors can be located in different rooms or outdoors.
• Every sensor must be assigned its own sensor number (= number of the transmission channel) (1 to 3).
• For the snow and frost warning, the weather station only analyses the information from the sensor with the
lowest number (by default 1). If only one sensor is connected to channel 1, 2 or 3, the display will function
on all 3 channels.
Procedure:
1. Remove the battery compartment cover on the back of the wireless sensor.
2. Set a different sensor number for each wireless sensor with the sliding switches.
3. Put the battery compartment cover back in place on the wireless sensors. If adding another sensor later
or after changing the batteries:
CH
4. Press and hold the
will now retrieve the weather information from all available wireless sensors.
Base unit
1. Remove the battery compartment cover.
2. Insert 3 LR6 (AA) / 1.5 V batteries facing in the direction indicated on the bottom of the battery
compartment. Make sure that the poles of the batteries are correct (+/-).
3. Put the battery compartment cover back in place and close it.
4. Wait several minutes. The base unit needs this time to collect all the weather data.
button on the base unit until the radio frequency symbol
Do not press any buttons while switching
flashes. The base unit